|
|
|
Remote Control User Reviews
|
|
|
|
|
|
|
The following page was printed from RemoteCentral.com:
User reviews for the Sony RM-V60 from Sony Electronics. |
| Ratings | Reviews | MSRP (USD) |
Average: 2.41/5.00 Median: 2.33/5.00 | 9 | $34 |
The RM-V60 is an 8-device pre-programmed remote control with LCD display and backlit keypad.
|
|
Now viewing user reviews page 1 of 2 for the Sony RM-V60 remote.
|
|
Written by Kurt from MD. The reviewer has used this remote control for more than two years. |
Review 5 made on Monday December 24, 2001 at 1:42 PM. |
Review: | http://www.sel.sony.com/SEL/se...emote.shtml#s10
Section IV. Search For The Correct Code Number Using The Remote CH+ Button
If, after trying all the codes listed for the component the Commander still does not work properly, or it the component is not listed, try the steps below. Power on the component to be set up. Insert a tape or disc if necessary.
On the remote, press the SET button with a ball-point pen tip, or similar pointed object, and release it. "SET" will appear in the display window.
On the remote, press the TV, VCR, DBS/CBL, RECEIVER, CD, TAPE, AV1 or AV2 button that corresponds to the component being set up. NOTE: For DBS/CBL, TAPE, AV1 and AV2 buttons, press each button repeatedly until the desired component is displayed (see below).
When the buttons are pressed for the first time, the component and its code number that is preset at the factory are displayed.
NOTE: The Commander is not preset at the factory to operate a Cable box (CATV). Press and release the CH+ button. Then press and release the POWER button.
Repeat step 4 until the correct code number is found. Each time the CH+ and then the POWER buttons are pressed a new code number will be transmitted. NOTES: Keep trying until the component operates as follows: TV, VCR, Cable box, DBS tuner, receiver or LD player: the power turns off. CD player, tape deck, DAT deck, MD deck or LD player (those components whose power cannot be turned off using the remote commander): playback starts. (Make sure that the power is already turned on and that a tape or disc is inserted.) Cable box or TV without a power switch: the Channel+ function works. When the correct code is found, press and release the ENTER button to store the code number in the Commander's memory.
Turn on the component again; and on the remote, press the CH and VOL buttons. Check that the Commander is operating the other functions of the component by pressing the corresponding buttons on the Commander. If they seem to be working properly, the set up is complete.
|
|
Quality: | Features: | Value: |
|
|
|
Now viewing user reviews page 1 of 2 for the Sony RM-V60 remote.
|
|
|
|
|
|