The following page was printed from RemoteCentral.com:
This Wiki entry is maintained by Remote Central members - so if you spot an error or have additional information, please update it!
| | Brand: | Scientific Atlanta |
Device Type: | Cable Box |
Model/Series: | Explorer 8300HD |
Model Year: | Unknown |
Information: | [Link: cisco.com] |
Configurations: | Search the file area |
| | | | | | Dimensions: | 15.60" wide × 3.25" high × 11.20" deep 39.62 cm × 8.26 cm × 28.45 cm |
| | | | | | Notes: | No discrete codes exist, however a macro workaround is possible for SARA-based units (and NOT Passport).
First, go to the full Setup menu and under "Power On Keys", change the setting to "Power & Numeric" (if you do not have this option then the box is not running SARA and no macro is possible).
Power On Macro [0] [Delay] [Exit]
Power Off Macro [0] [Delay] [Power]
Note that the behavior of this macro, including how much delay is needed, can depend on the firmware version the local cable company is running.
If the cable company powers down the hard drive when the box is idle AND runs firmware that ALWAYS tunes a channel (even if the one entered doesn't exist), then you may find that the amount of delay needed when the drive is off is greater than the maximum command timeout when the drive is already on. The end result is that the box will likely tune channel 1 (or whatever is the first available channel) when powering on, a mild annoyance if it is configured to turn on to the last viewed channel.
For more advanced control systems, power sensors work great when the AC outlet is configured to turn off with the box. This is not available for all firmware versions. |
| |
|
|
Input Options
| | Infrared: | Yes |
IR Input Jack: | No |
Radio Frequency: | No |
RS-232 (Serial): | No |
Network IP: | No |
Bluetooth: | No |
USB: | No |
DC Trigger: | No |
| | | Output Ports
| | IR Output Jack: | No |
RS-232 Output: | No |
DC Trigger: | No |
| |
| |
|
Discrete Codes
| |
Power: | No - Workaround |
Inputs: | N/A |
Sound Modes: | N/A |
Picture Modes: | N/A |
Screen Modes: | No |
| |
| Delays/Timings
| | Power On: | Unknown |
Switch Inputs: | Unknown |
Inter-command: | Unknown |
| |
|
|
|
Important Codes & Commands |
No codes have been added for this model.
|
|
No files have been uploaded for this model. Use the red Wiki Toolbox below to upload a file! |
|
About this page...
This page contains information on how the Scientific Atlanta Explorer 8300HD can be controlled, along with useful tips, tricks and commands to make integrating this device into a universal remote control or other control system faster and more reliable.
This entry was last updated on Tuesday April 28, 2009 at 18:41 by Daniel Tonks.
|