Post 1 made on Saturday December 14, 2013 at 23:44 |
Chasewood Long Time Member |
|
|
We've recently replaced our Pronto with the iRule app running on iPhone. Overall, we've been pleased with the transition, but we still have a couple of problems to resolve. One is getting hold of some codes I need to drive some of the receiver functions. iRule provides most of the codes I need, but the following are missing: They are all invoked when the Onkyo remote is in Receiver mode: RETURN, RED, BLUE, YELLOW, GREEN. The colored buttons make the receiver cycle through various listening modes. I've searched the RC files and forums to the best of my ability but without success. Reading the IR codes onto my Pronto and then copying them into iRule has not worked. I am assuming the Onko uses different device codes when it receives commands via WiFi (IP in general?) from when it does so via IR. Any ideas?
|
|
Post 2 made on Thursday February 27, 2014 at 07:53 |
SysIntegration Advanced Member |
Joined: Posts: | December 2013 895 |
|
|
Are you still working on this?
Do you need the IP commands for these functions or the IR hex?
|
0101001101111001011100110100100101101110011101000110010101100111011100100110000101110100011010010110111101101110 |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.