Post 6 made on Wednesday January 17, 2024 at 18:06 |
CZ Eddie Long Time Member |
Joined: Posts: | March 2009 79 |
|
|
lol I wish
FOUND THE PROBLEM. Or at least, I narrowed it down to a particular device.
My URC KP-900 remote control is the culprit. Went back to finish my programming today. Noticed the KP-900 batteries were dead. Replaced them. About 15 minutes into a frustrating programming experience, I noticed that nothing was working again.
Sure enough, the RF LED on the sensor was lit up constant.
Thought about it a moment. Pulled the batteries from the KP-900 and sure enough, the RF interference went away.
A minute later, I duplicated the same situation.
Gonna try a factory reset on the KP-900 to see if that helps. It's a new-old-stock remote.
|
|
|